Answer
Remove the chainsaw’s primary cover by unscrewing it and pulling it off. Remove the air filter cover as well as the starter assembly by unscrewing and removing them. Fuel lines that are no longer in use should be removed from the carburetor, which should be easily accessible. Using pliers, remove the fuel filter and fuel lines from the inside of the gasoline tank.
In addition, what size gasoline line does a Craftsman chainsaw need is unknown.
A 3/16 x 3/32 gasoline line was utilised in conjunction with an 18″ bit. It’s a little tight around the waist.
Which gasoline line connects to the primer bulb and which does not?
From the top of the carburetor (straight nipple) to the small post on the rear of the priming bulb is where the (clear) fuel intake line is connected. It is connected to the bottom of the gasoline tank via the return line (blue), which originates from the long post on the rear of the priming bulb.
What is the location of the fuel line on a carburetor in this case?
Gasoline line should be fed in via a hole in the gas tank, then pulled back into the tank. Attach a weighted fuel filter to the end of the fuel line, so that it rests at the bottom of the tank. The bigger diameter gasoline line connects to the carburetor’s other surviving fitting, which is located on the side of the carburetor.
What is the proper way to adjust the carburetor on a Craftsman chainsaw?
The idle speed screw should be turned counterclockwise in 14 turn increments to slow the engine down until it is idles smoothly and the chain stops moving. It is necessary to adjust the idle-speed screw clockwise if the engine starts and runs but does not idle after the throttle trigger has been removed.
There were 36 related questions and answers found.
What is the best way to clean a gasoline line on a chainsaw?
If there is debris in the gas tank, your chainsaw may not be able to operate correctly. Using a clean cloth, wipe away any debris or dust from the gas tank lid and the top of the gas tank to prevent corrosion. Remove the chainsaw’s gas tank lid and place it in a well-ventilated location before starting it up. In the gas tank of the chainsaw, insert the straight part of your hand syphon into the opening.
Is it possible to replace the priming bulb on a chainsaw?
Instructions on how to change the primer bulb in a Poulan chainsaw (Model P3314) Let’s get this party started. Removing the primary bulb (at the top of the page) 1. Remove the top cover from the device. Remove the starter assembly from the vehicle. Remove the air filter housing from the vehicle. Remove the carburetor from the engine. Remove the purge bulb from the circuit. Installing the new primer bulb (at the top of the page) 7. Connect the purging bulb to the power source.
How do you adjust the carburetor on a chainsaw?
Procedure for Adjusting the Carburetor Locate a tiny flat-bladed screwdriver and set it aside before starting the saw. The first step is to inspect the saw’s air filter. Check the gasoline level in your vehicle. Start the engine and let it to warm up. To begin, adjust the idle speed to a comfortable level. Set the low-speed fuel adjustment to your liking. Return to step (4) and adjust the idle speed to your liking.
